National Transportation Safety Board Aviation Accident Final Report Location: Santa Paula, CA Accident Number: WPR16FA118 Date & Time: 05/28/2016, 1515 PDT Registration: N80681 Aircraft: MOORE JOSEPH O VARIEZE Aircraft Damage: Destroyed Defining Event: Loss of engine power (total) Injuries: 2 Fatal Flight Conducted Under: Part 91: General Aviation - Personal Analysis The airline transport pilot and a passenger departed on a local area flight; shortly after takeoff, the engine experienced a total loss of power. To the northwest of the accident site was an open field and a road; both were available to use for landing but presented challenges. The field had been recently plowed and there was auto traffic on the road. It was likely that the pilot was attempting to land on the road but struck power lines during the descent. The airplane came to rest in a lemon orchard and was subsequently consumed by a postcrash fire. Visual examination of the engine revealed thermal damage. The engine crankcase was disassembled; the main bearings on the left crankcase half were dark in color and exhibited pitting. The camshaft drive gear cluster displayed nine broken teeth, most of which were found in the oil sump. Metallurgical examination revealed that three of the camshaft drive gear teeth failed in fatigue, which subsequently resulted in the overstress failure of the other six teeth. The fatigue initiated at sharp corners formed during hand-grinding of the forward faces of the teeth while dressing the edges and removing burrs from the teeth during manufacture. Airplane logbook entries revealed that the engine was assembled by a third party and installed new on the airframe about 13 years before the accident. Probable Cause and Findings The National Transportation Safety Board determines the probable cause(s) of this accident to be: A total loss of engine power due to fatigue failure of the camshaft drive gear teeth. Page 1 of 8 Findings Aircraft Engine (reciprocating) - Fatigue/wear/corrosion (Cause) Environmental issues Wire - Contributed to outcome Page 2 of 8 WPR16FA118 Factual Information History of Flight Maneuvering Loss of engine power (total) (Defining event) Emergency descent Collision with terr/obj (non-CFIT) On May 28, 2016, about 1515 Pacific daylight time, an experimental amateur-built VariEze airplane, N80681, impacted power lines and terrain following a total loss of engine power near Santa Paula, California. The airline transport pilot and passenger were fatally injured. The airplane was destroyed in the postcrash fire. The airplane was privately owned and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91. Visual meteorological conditions prevailed for the local area flight which departed Santa Paula Airport (SZP), Santa Paula, California, about 1510. Two witnesses observed the airplane flying overhead about 200-300 ft above ground level (agl), and they heard the engine sputtering. The airplane descended from their view as it passed behind a hill. When the airplane came back into their view, it was in a steep 45° left turn. The airplane struck power lines, and then impacted the ground; the power lines were about 75-ft tall. Witnesses reported hearing an explosion, and then seeing fire erupt from the accident site. An ear witness to the accident reported that after the airplane took off, the pilot radioed him that his engine had quit. There were no further communications between the pilot and the ear witness. Pilot Information Certificate: Airline Transport Age: 61, Male Airplane Rating(s): Multi-engine Land; Single-engine Land Seat Occupied: Unknown Other Aircraft Rating(s): None Restraint Used: Unknown Instrument Rating(s): Airplane Second Pilot Present: No Instructor Rating(s): Airplane Multi-engine; Airplane Single-engine; Instrument Airplane Toxicology Performed: Yes Medical Certification: Class 2 With Waivers/Limitations Last FAA Medical Exam: 07/18/2015 Occupational Pilot: No Last Flight Review or Equivalent: 06/21/2014 Flight Time: (Estimated) 3500 hours (Total, all aircraft), 0 hours (Total, this make and model) Page 3 of 8 WPR16FA118 The pilot, age 61, held an airline transport pilot certificate with ratings for airplane single- and multi-engine land. He also held a flight instructor certificate for airplane single- and multiengine, instrument airplane, and a mechanic certificate for airframe and powerplant. The pilot was issued a Federal Aviation Administration (FAA) second-class medical certificate on July 18, 2015, with the limitation that he must wear corrective lenses. On that date, he reported 3,500 hours of total flight experience, with 30 hours accrued in the previous six months. Review of the pilot's personal logbook indicated that he had 2,525.8 total hours of flight experience, with 3.6 hours in the previous six months. Aircraft and Owner/Operator Information Aircraft Manufacturer: MOORE JOSEPH O Registration: N80681 Model/Series: VARIEZE NO SERIES Aircraft Category: Airplane Year of Manufacture: 1980 Amateur Built: Yes Airworthiness Certificate: Experimental Serial Number: 1424 Landing Gear Type: Retractable - Tricycle Seats: Date/Type of Last Inspection: 05/01/2016, Condition Certified Max Gross Wt.: Time Since Last Inspection: Engines: 1 Reciprocating Airframe Total Time: Engine Manufacturer: CONT MOTOR ELT: Engine Model/Series: O-200X Registered Owner: On file Rated Power: 100 hp Operator: On file Operating Certificate(s) Held: None The airplane, serial number 1424, was manufactured in 1980, and equipped with a Continental Motors, Inc., O-200-X (experimental), 100-hosepower reciprocating engine. Review of the airplane's maintenance logbook indicated that a condition inspection was completed on May 1, 2016, with no airframe total time noted. Previous entries indicated a total airframe time of 2,576.0 hours and a total engine time of 324.3 hours as of September 30, 2015. Additional aircraft records revealed that that a zero-time engine was installed new in the airplane on March 18, 2003. The engine was assembled from new parts obtained from Continental Motors Inc. (Teledyne Continental Motors) in August of 2002. In December of 2002, a new crankshaft from A.E.R.O., Inc. was shipped to the builder. After the rebuild was completed, the engine was installed in the airplane in May 2003. Page 4 of 8 WPR16FA118 Meteorological Information and Flight Plan Conditions at Accident Site: Visual Conditions Condition of Light: Day Observation Facility, Elevation: KSZP, 259 ft msl Observation Time: 1455 PDT Distance from Accident Site: 4 Nautical Miles Direction from Accident Site: 63° Lowest Cloud Condition: Clear Temperature/Dew Point: 18°C / 12°C Lowest Ceiling: Overcast / 1400 ft agl Visibility 10 Miles Wind Speed/Gusts, Direction: 10 knots/ 18 knots, 220° Visibility (RVR): Altimeter Setting: 29.89 inches Hg Visibility (RVV): Precipitation and Obscuration: No Obscuration; No Precipitation Departure Point: SANTA PAULA, CA (SZP) Type of Flight Plan Filed: None Destination: SANTA PAULA, CA (SZP) Type of Clearance: None Departure Time: 1510 PDT Type of Airspace: Unknown Airport Information Airport: SANTA PAULA (SZP) Runway Surface Type: N/A Airport Elevation: 248 ft Runway Surface Condition: Dry Runway Used: N/A IFR Approach: None VFR Approach/Landing: Forced Landing Runway Length/Width: Wreckage and Impact Information Crew Injuries: 1 Fatal Aircraft Damage: Destroyed Passenger Injuries: 1 Fatal Aircraft Fire: On-Ground Ground Injuries: N/A Aircraft Explosion: None Total Injuries: 2 Fatal Latitude, Longitude: 34.322778, -119.149167 The accident area was in a rural part of Santa Paula. To the northwest of the accident site was a road and an open field. The field was unplanted and open but had furrowed rows. Adjacent to the road was the lemon orchard where the airplane came to rest. The initial impact point was identified as powerlines about 162 ft south of the main wreckage. A debris path extended from the powerlines on a magnetic heading of 325°. The airplane came to rest on a magnetic heading of 140° and was consumed by a postcrash fire. All major components of the airplane were accounted for at the accident site, and control continuity was established to each of the flight Page 5 of 8 WPR16FA118 control surfaces. Visual examination of the engine revealed varying degrees of thermal damage. The engine was equipped with a Light Speed Engineering, LLC, electronic ignition system. The mounting pads for the magnetos, mechanical fuel pump, electric starter, and vacuum pump were covered by blank plates. The ignition harness was thermally damaged. The throttle cable arm remained secured at the throttle plate shaft. The throttle cable arm and the carburetor mixture arm could not be tested for proper operation due to the thermal damage. Internal timing of the engine was compromised due to mechanical damage to the crankshaft cluster gear and the camshaft gear. The top spark plugs were removed. The spark plugs from cylinder Nos. 1, 2, and 4 were oil contaminated; cylinder No. 3 was dry and exhibited normal combustion signatures. The oil pump was disassembled. The cavity displayed some scratches on the walls. The oil pump gears exhibited pitting of the gear teeth surfaces. The oil filter was disassembled, and the internal paper filter element had turned to ash because of the postcrash fire. All four cylinders remained intact but sustained thermal damage. The valves were intact with no signs of mechanical damage. The rocker arms were intact and in place. The piston rings and pins showed no visible damage. The Nos. 1, 2, and 4 connecting rods and caps were normal and the rod bearings exhibited normal coloration and wear patterns. The No. 3 connecting rod and cap appeared normal; however, the rod bearings were pitted on the surface material. The engine was rotated manually; it rotated fully in one direction, but binding was noted during rotation in the opposite direction. The engine crankcase was separated. The engine data plate had sustained thermal damage and was unreadable. The main bearings on the left crankcase half exhibited a dark coloration and some pitting. The main bearings on the right crankcase half, displayed normal coloration and wear patterns. The rear and center main crankshaft bearing journals were dark and discolored. The crankshaft cluster gear and the camshaft gear exhibited mechanical damage. The camshaft appeared normal. Medical And Pathological Information The Ventura County Medical Examiner's Office, Ventura, California, performed a postmortem examination of the pilot. The cause of death was reported as thermal injuries due to an aircraft accident. The FAA Bioaeronautical Sciences Research Laboratory, Oklahoma City, Oklahoma, performed forensic toxicology on specimens from the pilot. The results were negative for carbon monoxide, volatiles, and tested-for-drugs. A cyanide screen was not performed. The toxicology report yielded positive results for: Page 6 of 8 WPR16FA118 21 (mg/dl) Glucose detected in Vitreous 519 (mg/dl) Glucose detected in Urine 5.6 (%) Hemoglobin A1C detected in Blood (Cardiac) Tests And Research The crankshaft with camshaft drive gear cluster, main bearings, and the camshaft with gear were submitted to the National Transportation Safety Board Materials Laboratory in Washington, DC, for further examination. The crankshaft was intact but discolored at several bearing locations. All three main bearing journals and cylinder Nos. 2 and 3 journals were darkened on the same side; consistent with thermal damage from the postcrash fire. The camshaft drive gear ring of the crankshaft gear cluster displayed 9 consecutive fractured gear teeth. Large pieces of 8 of the teeth were recovered from the oil sump, along with several smaller pieces. A magnified optical examination of the fractured gear teeth surfaces revealed fatigue progression beach marking on the fracture surfaces of teeth Nos. 1, 2 and 3. The remaining teeth fractures were consistent with overstress. Scanning electron microscope imaging verified that the fatigue initiation location was near the base of each tooth, about 0.025 inches outboard of the root diameters for teeth Nos. 1 and 2. Administrative Information Investigator In Charge (IIC): Tealeye Cornejo Adopted Date: Additional Participating Persons: David Voelker; Federal Aviation Administration; Van Nuys, CA 05/09/2018 Mike Council; Continental Motors Inc.; Mobile, AL Publish Date: 05/09/2018 Note: The NTSB traveled to the scene of this accident. Investigation Docket: http://dms.ntsb.gov/pubdms/search/dockList.cfm?mKey=93260 Page 7 of 8 WPR16FA118 The National Transportation Safety Board (NTSB), established in 1967, is an independent federal agency mandated by Congress through the Independent Safety Board Act of 1974 to investigate transportation accidents, determine the probable causes of the accidents, issue safety recommendations, study transportation safety issues, and evaluate the safety effectiveness of government agencies involved in transportation. The NTSB makes public its actions and decisions through accident reports, safety studies, special investigation reports, safety recommendations, and statistical reviews. The Independent Safety Board Act, as codified at 49 U.S.C. Section 1154(b), precludes the admission into evidence or use of any part of an NTSB report related to an incident or accident in a civil action for damages resulting from a matter mentioned in the report. Page 8 of 8 WPR16FA118